RAID Data Recovery Tips and Tricks

Often, important data is stored in reliable RAID systems. the first reason is that raid systems are used as they’re more fault-tolerant. In other words, it’s easy to configure RAID systems while the system remains running. The failing drives are often replaced without shutting down the whole system. during this article, we are getting to mention a couple of tips and tricks for raid data recovery.

As with the other device , RAID drives also are susceptible to failure. If one drive fails, it’s possible to offset the failure. However, this is often impossible if tons of drives fail. Typically, many drivers within the system tend to fail.

Keep in mind that RAID systems contains an equivalent hard drives found during a pc . Therefore, these systems have problems almost like those of private computers. In fact, engineers got to affect complex problems once they need to fix RAID systems. Common problems include drive failures, controller failures, and accidental reconfiguration of RAID drives.

Although RAID systems are much stronger and reliable, they’ll have problems from time to time. Given below are a couple of tips that you simply can follow to affect the RAID failure, prevent further loss and recover the lost data.

DON’T DO-IT-YOURSELF!

Some people make the error of recovering data from their RAID drives. this is often a standard mistake. albeit you recognize the way to retrieve data from a tough drive, confirm you do not roll in the hay yourself.

For data recovery, you’ve got a better rate of success during the primary attempt. Therefore, it’s an honest idea to contact knowledgeable data recovery service. this is often important if you would like to stop further loss and recover the maximum amount data as possible.

DON’T attempt to REBUILD THE RAID

Another common mistake is to rebuild the RAID. Doing so may overwrite the knowledge on the controller. This information tells the RAID controller how and where to urge the specified data. Rebuilding the RAID will make it far more difficult or maybe impossible to seem for and recover The Lost files.

DON’T attempt to REMOVE THE DRIVES

It is not an honest idea to get rid of the drives from the RAID array. Doing so may overwrite important data. If you’ve got to get rid of the drives for a few reason, confirm to label them first. Once you’ve got labeled them supported their order, you’ll remove them and put them back within the same order.

DON’T use Recovery Tools

Again, you’ll not want to run any data recovery tools as these tools may change data. As a result, you’ll find it hard to recover the lost data employing a different technique. So, it’s better to not use any data recovery software.

DON’T FORMAT or Reinitialize

If you format or reinitialize the drives, this might overwrite the info pointers and catalogues. This process will delete your important data.

DON’T Use UNCONFIRMED BACKUPS

If you’re 100% sure that the backups you created contain an equivalent data stored on the RAID drives, you’ll restore your critical data from the backups. However, if you’re unsure , confirm you do not attempt to restore data from doubtful backups.

So, confirm you follow the following pointers to recover data from RAID drives.