difference between ADSL and Broadband

difference between ADSL and Broadband

What is the difference between ADSL and Broadband?

Broadband is a special type of telecommunication data technology that provides much higher speeds compared to standard dial-up connections. The technology also offers a variety of DSL (Digital Subscriber Line) connections, of which ADSL (Asynchronous Digital Subscriber Line) is one: ADSL uses copper wiring networks to provide high-speed data services Provides simultaneous transmission of voice and data.

What is ADSL?

Asymmetric Digital Subscriber Line (ADSL) is a very popular form of DSL technology. As the name implies, ADSL acts asymmetrically when providing download and upload speeds. This is one of the main reasons for the popularity of ADSL because it can provide higher reception frequency bandwidth (138 kHz to 1104 kHz) compared to the transmission frequency bandwidth (26.075 kHz to 137.825 kHz).

In general, ADSL is provided using a similar infrastructure with voice connectivity, so it requires a special splitter to detect and separate the two bandwidths of audio and data. This splitter is usually installed at the consumer site and the isolated data signals are sent directly to the ADSL modem or a router for modulation and demodulation. The main problem with ADSL is signal attenuation over long distances.

ADSL can generally be distributed at short distances from the call center, usually between 4 and 5 km. To exchange communication lines, a digital subscriber line access multiplexer (DSLAM) device, which is another type of frequency divider for separating the audio band from the telephone network, is added to the end. The data is then routed over the telephone company’s data network and finally connected to the main data protocol-based Internet protocol.

ADSL is a two-way data exchange solution and is usually established using a pair of copper wires based on one of the frequency division duplex (FDD), time-division duplex (TDD) or echo-canceling duplex (ECD) technologies. There are several types of ADSL technology today, such as ADSL 2 and ADSL 2+. These newer models provide higher data exchange rates. ADSL 2 provides speeds of up to 12,000 kbps and ADSL 2+ provides speeds of up to 24,000 kbps.

What is Broadband?

Broadband was initially introduced as a technology independent of dial-up services that offered wider bandwidth. This technology is available in two formats DSL or cable. The International Telecommunication Union (ITU) has defined broadband as a connection that provides a higher data rate than the standard data rate of 1.5 Mbps.

In addition, broadband transfer technologies were intended to take advantage of the wide bandwidth provided by fiber optics. Broadband provides access to quality Internet services for streaming media, games, Internet telephony and interactive services.

There are many different types of digital subscriber line services (DSL) today, including SDSL (symmetric Digital Subscriber Line) and HDSL (High-bit-rate Digital Subscriber Line). The basis of all these technologies is the assurance that digital information is transmitted through high-bandwidth channels.

What is the difference between ADSL and Broadband?

  • ADSL is a type of broadband technology, so both have the same features in terms of network architecture.
  • ADSL connections work very well when there is a very high demand for data, while broadband can provide solutions to provide the same bandwidth without any restrictions on sending and receiving.
  • Broadband includes a variety of data transmission technologies including cable, DSL, mobile and wireless, but ADSL only supports DSL technology on copper cable.
  • ADSL may not be available in all areas, as the distance between the telecommunications company and the consumer is limited. But broadband service providers can use other types of technology, such as cable and satellite, to avoid this limitation.

See Also NAT and NAPT What The Difference

follow on facebook
follow on linkedin
follow on Reddit