DNV Leak is a powerful yet simple software to check fluid leaks by frequency analysis. This method can be used to open and close an oscillating valve at the bottom of the pipe and analyze the frequency response of the system in a certain limit and check the changes before and after the leakage, the location of the leakage can be accurately determined.
This method also takes into account the friction in the pipes and therefore it is one of the most accurate methods in this field. This method detects noises from the range of 0.5 db and above. Various softwares have been provided to perform calculations related to this method, and DNV Leak is one of the appropriate programs in this regard. This program is organized and with a systematic approach, it is able to detect the leakage currents of different equipment and devices, which is also able to verify and evaluate the results.
The organized approach of this program means that you are able to perform all types of analysis automatically and guided by the program, which saves a lot of time compared to the manual method. This product can be used to detect leaks from all types of devices such as pipes, valves, pumps and related equipment and in fact any type of pipe and duct. Through its special methods and algorithms, DNV Leak notifies you of potential leakage risks through frequency analysis and thereby prevents potential risks before they occur. This product has a complete database of all types of leakage currents, including UK HSE and HCRD, which can be used for all types of piping systems and related equipment.
Required DNV Leak system:
Supported Operating Systems: Windows Vista / Seven
First, install the software by running the setup.exe file from DNV Leak 3.3installLeak_Installation. Then right-click on the LEAK_3_3_0_7 folder in the program installation path and select Properties. Go to the Security tab and click Edit. Now select your username in the first drop-down and click on Full control in the bottom drop-down section and OK. Then go to the General tab and remove the Read-only tick and click OK.
Now copy the Patcher file in the patch folder to the default path DNVSLEAK_3_3_0_7bin and run it with Run as administrator and click on Patch. A crack success message should be displayed.
This version was installed and successfully activated on Windows 10 64-bit on June 13, 1997.
Last Updated on June 10, 2023 by admin